Adding Elysium to your wallet

Tartarus runs on Elysium, so your wallet needs the Elysium network, set to the Tartarus RPC. Enter these details once and you are done.

If your wallet asks for the chain ID in hex, it is 0x1863d.

Add it manually#

1. Open your wallet's network settings. In most wallets this is Add network or Add a custom network.
2. Enter the details above, and paste the RPC URL exactly as shown.
3. Save, then switch to Elysium. Your address is the same as on every other EVM chain.

You can also let the site do it. The first time you make a transaction on Tartarus, your wallet will ask to add or switch to Elysium.

Already have Elysium in your wallet?#

Check which RPC it uses, and change it to the one above if it differs. Wallets keep their own network settings and ignore what a site suggests, so adding the network again usually does nothing.

This matters because most community RPCs only pass along transactions for their own apps. With one of those, a Tartarus trade can fail with a generic error or stay pending forever, even though your balance looks fine.

The Tartarus RPC gets trades and launches onto the chain, falling back through HyperEVM if the sequencer relay refuses them. Other transactions may be declined, including plain HYPE transfers. See Which RPC to use.

Get HYPE on Elysium#

HYPE pays for gas on Elysium. Move some over from HyperEVM on the Bridge page, which takes about a minute. Bringing it back takes about 6 days, so see Bridging HYPE first.